K+M Carbide Cutting Pilot w/Flutes, 25 Calibre Bullet Brand Style_Naturalis The CB1100-12 wad was designed

The CB1100-12 wad was designed for use in 7/8 oz to 1 oz trap

377 Sectional Density 0

Over-molded front and rear supports protect the firearm's finish

25 Calibre Diameter (Inches) 0

K+M Carbide Cutting Pilot w/Flutes, 25 Calibre Bullet Brand Style_Naturalis The CB1100-12 wad was designedThis finely ground carbide cutting pilot, designed for use with the K+M case neck turning body, has four cutting flutes used to remove the doughnut that can form at the inside neck wall and shoulder junction. If you are noticing the formation of a doughnut, this tool will remove the excess material without affecting inside neck diameter allowing for uniform bullet seating and eliminate powder gas restriction. There is also less friction between brass